9/25/2023 0 Comments Dead space 3 rotate plasma cutterUnfortunately these lasers wont be powerful enough to light matches or pop balloons and you won’t be able to see the beam itself without some atmospheric assistance ( smoke, etc.). There are three in total (of course) each wired to its own micro boost drive and connected to the power supply. I began gathering materials and hardware almost immediately and the first components to arrive, and perhaps the coolest part of the build, were the lasers! After much research I decided to go with mini blue laser diodes due to the small amount of space available in the front of the cutter. You can see a sample of the blueprint below. ![]() Coming in at just over 16 inches this is going to be quite intimidating when completed. Using these references I then drew up some blueprints to give myself a template for creating the pieces and scaled it to the right proportions. To get started I gathered up any and all references I could find of the new Plasma Cutter including an excellent concept sketch from the dev team limited edition of the game. ![]() The goal for this project is to not only incorporate the iconic three-point laser sight into the design, but also allow the front of the cutter to rotate as it does in the game. I was recently commissioned to build a replica of the New Dead Space 3 Plasma Cutter. Personally, the style of the new Plasma Cutter is my favorite so far so I was very excited to get the opportunity to build it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |